FAGOR Monoblock Refrigerator GN 2/1 1144 L Off-Cycle Defrost

A professional refrigerator built for high-volume kitchens, this unit uses a monoblock cooling system that keeps the compressor and evaporator as a single sealed assembly. The system circulates cold air through a fan, spreading it evenly across every shelf so that every tray of ingredients stays at the same temperature. Off-cycle defrost works by temporarily stopping the compressor; when the cooling stops, the evaporator warms just enough to melt any frost without raising the cabinet temperature. This method avoids the need for heating elements and keeps the interior drier, reducing ice build-up between manual defrosts. The sequence begins when the operator loads the six removable GN 2/1 epoxy-coated shelves. Each shelf can be adjusted in 60 mm increments across 23 possible positions, allowing the cabinet to be reorganised for tall containers or shallow trays. The doors open with ergonomic handles and close on a 60 mm-thick insulation layer that slows heat transfer from the kitchen. Inside, LED lighting turns on automatically, giving a clear view of every shelf without adding heat. The electronic control panel displays the current temperature and allows the operator to set the range between 0 °C and +8 °C, the standard band for fresh ingredients that must stay above freezing but below the point where bacteria multiply quickly. The cabinet is constructed from stainless steel inside and out, chosen for its resistance to corrosion, ease of cleaning and durability under daily use. The monoblock cooling unit is mounted on the top of the cabinet, leaving the full interior volume free for storage and making the evaporator accessible for maintenance without moving the refrigerator. Adjustable legs raise or lower the unit from 130 mm to 200 mm, allowing the operator to level it on uneven floors and to clean underneath. A cooling power of 0.436 kW indicates the rate at which the unit removes heat from the cabinet. This rating determines the electrical load on the kitchen circuit and the speed at which the refrigerator can pull down the temperature of a new load of warm ingredients. The 1144 L volume provides space for large quantities of prepared dishes, while the 270 kg weight shows that the unit is built for permanent installation and will not be moved frequently. The footprint of 1318 mm by 796 mm defines the floor space it occupies, which must be kept clear for door swing and ventilation. Stainless-steel interior and exterior wipe clean in seconds with a damp cloth after every service, so the unit is ready for the next rush without scrubbing or chemicals. The stainless steel interior and epoxy-coated shelves can be wiped down with standard kitchen sanitiser. The removable shelves allow the operator to take them out for thorough cleaning in a sink. The monoblock cooling system simplifies maintenance because the entire refrigeration circuit is contained in one unit that can be serviced without dismantling the cabinet. The off-cycle defrost method reduces the frequency of manual defrosting, but when it is needed the operator can empty the cabinet and let the frost melt naturally without running a defrost cycle that would raise the temperature. The model is available in an R600a refrigerant version with a 60 Hz power supply, specified as a separate article. The unit is classified as C energy efficiency class, reflecting its annual electricity consumption of approximately 756 kWh under standard conditions. This refrigerator is designed for professional kitchens that use gastronorm trays and need a large, adjustable storage volume with stable temperature control.