FORCAR PIA4714 Infrared Lamp Frame for Holding Heat

An overhead infrared frame holds plated dishes at serving temperature without drying or overcooking. The lamp emits radiant heat that warms the surface of the food while the interior stays moist. Because the heat travels in straight lines, the frame is positioned directly above the pass or counter where plates are assembled, so each dish receives consistent warmth until it is taken to the table. The operator hangs the frame from a ceiling bracket or wall arm at the height specified by the kitchen layout. Once the power is switched on, the lamp reaches operating temperature within seconds. Plates are placed underneath; no contact is needed. The single control adjusts the intensity of the infrared output, allowing the chef to match the heat level to the type of dish and the expected holding time. The frame is built from stainless steel tubing and sheet, chosen for corrosion resistance and ease of cleaning in a busy kitchen. The lamp housing is sealed to prevent grease ingress, and the electrical components are rated for the 230 V, 50 Hz supply used in British commercial kitchens. A power rating of 0.25 kW keeps the electrical load low, suitable for a dedicated circuit or a shared worktop supply. The 450 mm width and 680 mm depth create a coverage area that accommodates standard hotel pans and plated mains without crowding. The 250 mm height allows clearance for stacked plates and serving utensils. The sealed infrared lamp housing stays grease-free while the polished frame rails collect only light dust that brushes off before the lunch service begins. The lamp itself is not user-serviceable; when the filament expires, the entire lamp assembly is replaced as a single unit. The PIA4714 is a single-lamp frame. No other variants are listed in the FORCAR catalogue for this article.