Forcold M-GN3100TN-FC 1795 mm Refrigerator Table

A refrigerator table combines chilled storage with a worktop surface, keeping ingredients within reach while maintaining safe holding temperatures. The refrigeration system removes heat from the interior and expels it outside, using a compressor, condenser and evaporator. A thermostat cycles the compressor to hold the set temperature, ensuring food stays fresh without freezing. The Monobloc unit integrates all refrigeration components into a single module, allowing the appliance to be plugged in and ready without on-site refrigerant charging or complex assembly.

The operator loads ingredients onto the two GN1/1 grids inside the cabinet. The door opens with a self-closing spring, reducing the risk of warm air entering if left ajar. A removable gasket snaps out without tools for cleaning, and the door can be swapped with those from compatible drawer units. The bottom of the cabinet has rounded corners to prevent debris accumulation, and the worktop provides a stable surface for food preparation or plating.

The cabinet is constructed with a stainless steel exterior and interior, chosen for durability and hygiene. The Monobloc refrigeration unit is housed in a thermally insulated plastic casing, designed for easy removal or replacement. Inside, the grids rest on supports, and the door seal ensures an airtight closure when shut.

Controls are minimal: a thermostat maintains the temperature between 0 °C and +8 °C, suitable for holding chilled ingredients without freezing them. The 260 W power rating indicates the electrical load the appliance draws during operation, while the 220-240 V, 50 Hz voltage requirement matches standard UK mains circuits.

The 1795 mm width provides ample storage and worktop space, fitting standard kitchen layouts. The 700 mm depth allows it to sit against a wall or between other units, and the 850 mm height aligns with typical worktop levels for comfortable use. The weight of the unit ensures stability during operation, while the compact Monobloc design simplifies installation and servicing.

Cleaning involves wiping down the stainless steel surfaces and removing the door gasket for thorough washing. The grids and telescopic slides can be taken out for separate cleaning, and the rounded corners of the interior prevent dirt from collecting in hard-to-reach areas. The Monobloc unit's plastic casing is designed for easy access during maintenance.

This model is part of the M series, which includes compatible drawer units for additional storage options. The door interchangeability allows operators to adapt the configuration as kitchen needs change.