LF Snap-In Gasket 660 x 385 mm for Professional Refrigeration

A snap-in gasket creates an airtight seal between a refrigeration door and its cabinet by pressing into a pre-formed channel. The flexible lip compresses against the metal frame, blocking warm air from entering and cold air from escaping. This method removes the need for adhesive or screws, allowing the gasket to be replaced quickly when it hardens or cracks over time.

The operator aligns the gasket with the channel, starting at one corner, and presses it firmly into place. The lip flexes and locks into the groove, forming a continuous seal around the perimeter. No tools are required; the fit is secure once the entire length is seated.

Constructed from a flexible polymer, the gasket resists hardening at low temperatures and remains pliable through repeated opening and closing. The grey colour matches standard refrigeration finishes, blending with the door or panel it seals.

The 660 mm by 385 mm size fits specific Friginox and ODIC refrigeration units, replacing worn or damaged gaskets on doors and panels of that dimension. The footprint corresponds to the channel cut into the metal frame, ensuring a precise fit without trimming or modification.

Cleaning follows from the material: a damp cloth removes surface dirt, while a mild detergent solution lifts grease without damaging the polymer. Regular wiping prevents build-up that could interfere with the seal.

The gasket is supplied as a single continuous length, cut to the stated dimensions. No additional sizes or colours are offered under this article.