Novameta BHS-MP3-WLX-130/70/90 reinforced worktable with cutting-board shelf

A stainless-steel worktable built to hold a plastic cutting board at a comfortable working height while keeping the board stable under heavy chopping. The board sits on a reinforced shelf just below the main worktop, so the operator can slide ingredients on and off without lifting. The shelf is sized for boards 300 mm or 400 mm wide and up to 30 mm thick, giving a firm, non-slip surface that reduces knife wear and protects the steel top from scratches.

The table is a welded frame of square stainless-steel tube: 40×40 mm legs, 40×20 mm and 25×25 mm cross-braces. This construction carries the load of the board, the ingredients and the operator leaning on the edge without flexing. Adjustable feet at each corner level the table on uneven floors and raise or lower the working height by up to 65 mm, so the same unit fits different kitchen layouts and staff heights.

To use the table, the operator places a plastic cutting board of the correct width on the shelf, slides it forward until it butts against the front rail, and begins work. The board is held by its own weight and the lip of the shelf, so it does not shift during chopping. When the task is finished, the board lifts out for cleaning and the shelf remains clear for other uses.

The main worktop is a flat stainless-steel surface that can be used for additional prep or as a landing area for ingredients. The entire unit is made of stainless steel, including the feet, so it resists corrosion and can be wiped down with standard kitchen sanitiser. The welded joints eliminate crevices where food debris could collect, and the open frame allows easy access for cleaning underneath and around the legs.

The table is supplied in three widths—800 mm, 900 mm and 1000 mm—each with the same 1300 mm length and 900 mm height. The adjustable feet allow the unit to be levelled on any floor, and the 700 mm depth provides enough space for a cutting board and ingredients without overhanging into the aisle.

Cleaning is straightforward: the plastic board is removed and washed separately, while the stainless-steel frame and shelf are wiped with a damp cloth and sanitiser. The open construction means there are no hidden corners where dirt can accumulate, and the adjustable feet can be lifted to clean underneath the unit.