Novameta LSX2-100/50/60 Wall Shelf System with Two Shelves

Two rigid stainless shelves bolt directly to the wall above your prep line, keeping utensils and ingredients within arm's reach while leaving the floor clear for mobile racks and trolleys. The shelves are secured to the wall with brackets, transferring the weight directly to the building structure rather than relying on legs or a base. This arrangement keeps the area beneath clear for trolleys, bins or foot traffic, while the shelves themselves hold ingredients, utensils or small appliances within arm's reach during service. The system consists of two horizontal stainless-steel shelves, each supported by a pair of wall brackets. The shelves are flat, unobstructed panels that allow items to slide on and off easily. Because the shelves are fixed to the wall, they cannot tip or sway, even when fully loaded. The height between the shelves is set to allow standard gastronorm trays or bulk containers to fit without interference, so the same space can be used for mise-en-place, storage or temporary holding during peak service. To install, the wall brackets are first fixed to the wall at the desired height and spacing. The shelves are then placed onto the brackets and secured with the supplied fasteners. Once mounted, the shelves are ready for immediate use; there are no moving parts to adjust or maintain. The operator loads each shelf with up to 50 kg of equipment or supplies, ensuring that the weight is distributed evenly across the surface to prevent overloading any single bracket. The construction is entirely stainless steel, including the shelves, brackets and fasteners. Stainless steel is non-porous, so it does not absorb moisture or food residues, and it withstands the heat and humidity of a professional kitchen. The surface can be cleaned with standard kitchen detergents and sanitising agents without risk of corrosion or discolouration. The edges of the shelves are rolled to eliminate sharp corners, reducing the risk of injury and making cleaning easier. The system is controlled by the physical arrangement of the shelves: the operator chooses the height of each shelf during installation, and that position remains fixed. There are no electrical or mechanical controls to set. A load capacity of 50 kg per shelf means the system can support bulk ingredients, stacked trays or heavy small appliances such as mixers or blenders. The 1000 mm width provides enough linear space for multiple gastronorm containers side by side, while the 500 mm depth keeps items within easy reach without overhanging the worktop below. The 600 mm height between the floor and the lower shelf allows most standard trolleys to pass underneath, preserving floor clearance in busy kitchens. Cleaning involves wiping the shelves and brackets with a damp cloth and a mild detergent after each service period. Because the shelves are fixed to the wall, there are no legs or undersides to trap debris, so routine cleaning is quick and thorough. The stainless-steel surface does not require polishing or protective coatings, and it will not degrade under repeated cleaning cycles. The LSX2-100/50/60 is one configuration of the LSX modular system. Other widths, depths and numbers of shelves are available, and the manufacturer can produce custom sizes to match specific kitchen layouts or workflow requirements.