Novameta Rear Panel for Catering Equipment

A rear panel forms the back wall of professional catering equipment, shielding internal components from dust, grease and accidental contact while organising gas, water and electrical connections. It provides a secure mounting surface for taps, regulators and strain-relief clamps, ensuring that supply lines enter the appliance in a controlled, accessible manner. Without this panel, connections would be exposed, increasing the risk of snagging, contamination or short circuits in a busy kitchen environment.

The panel is fitted after the main chassis is positioned. The operator aligns the panel with the pre-drilled fixing points on the sides or base of the unit, then secures it with screws or bolts. Once in place, the panel creates a clean, enclosed rear cavity where gas hoses, water pipes and power cables can be routed neatly and clamped against movement. This arrangement simplifies maintenance: when a technician needs to inspect or replace a component, the panel is removed as a single piece, revealing all connections in an orderly layout.

Constructed from sheet metal, the Novameta A-DSU-G rear panel is cut to the standardised footprint of the equipment it fits. Its flat surface allows for straightforward cleaning with a damp cloth and mild detergent, removing accumulated grease without damaging the finish. No specialised tools are required for upkeep beyond the screws or bolts used during installation.

The panel is supplied as a single piece, ready for immediate fitting to compatible Novameta catering units. Its dimensions and fixing points match the manufacturer's original specification, ensuring a precise fit without modification.