Novameta stainless steel sink module with 300 mm high front panel Z-H0-SINK-100/63/86

A stainless steel sink module built for commercial worktops, shielding the operator with a 300 mm high front panel that blocks splashes from taps and bowls. The panel stands above the work surface, creating a barrier while the sink itself is set into the counter, allowing pots and trays to slide in and out without obstruction.

The unit is supported on adjustable legs that compensate for uneven floors; each leg moves through a 65 mm range, raising or lowering the module by up to 35 mm below or 30 mm above its nominal height. This adjustment keeps the worktop level and stable, preventing spills from bowls or draining boards.

Construction is fully welded stainless steel, chosen for resistance to corrosion and for hygiene; the material does not absorb moisture, odours or bacteria, and it withstands the acids and alkalis used in kitchen cleaning. The high front panel is integral to the frame, not a separate sheet, so it cannot shift or detach during use.

The footprint of 1000 mm by 670 mm fits standard worktop depths and leaves room for adjacent appliances or preparation areas. Height varies between 825 mm and 890 mm once the legs are set, matching the typical working height of chefs and kitchen staff.

Cleaning follows from the materials: stainless steel surfaces are wiped with a damp cloth and a mild detergent, then dried to prevent water marks. The adjustable legs are checked periodically to ensure they remain tight and the module stays level.