Novameta Table for Cutting Board with Frame BHS-MP3-WRX-150/70/90

A stainless steel worktable built to hold plastic cutting boards up to 400 mm wide, giving a stable, hygienic surface for food preparation. The frame supports the board at a fixed height, keeping the worktop clear while the board itself can be lifted out for cleaning or swapped between tasks.

The table relies on a rigid welded frame of stainless steel tubes. This construction resists flexing under load, so the board stays level even when heavy ingredients are chopped or rolled. Adjustable feet compensate for uneven floors, allowing the unit to sit firmly without wobble. The feet move through a vertical range, letting the operator set the exact working height for comfort and safety.

To use the table, the operator places a compatible plastic cutting board—either 300 mm or 400 mm wide—into the frame. The board rests on the cross-tubes and is held in place by its own weight. Once the board is in position, the worktop is ready for knives, bowls and ingredients. After use, the board lifts out for separate cleaning, leaving the stainless steel frame to be wiped down.

The frame is made from stainless steel tubes of 40×40 mm for the legs and 40×20 mm or 25×25 mm for the cross-members. The table top is a single reinforced sheet, welded to the frame for strength. Adjustable feet are stainless steel, threaded to allow fine height adjustment.

Controls are limited to the adjustable feet, which the operator turns by hand to raise or lower each corner. No electrical or mechanical settings are required.

A footprint of 1500 mm by 700 mm gives a generous work area while fitting into most professional kitchens. The 900 mm height is standard for worktops, allowing the table to sit alongside other equipment without awkward steps or reaches. The adjustable feet can fine-tune this height by up to 65 mm, so the table can be matched to existing counters or to the operator's preferred working posture.

Cleaning follows from the materials: the stainless steel frame and table top can be wiped with standard kitchen sanitiser. The plastic cutting boards are removed and washed separately, either by hand or in a commercial dishwasher. No hidden crevices or joints trap food debris, so maintenance is quick and thorough.

The table is offered in three widths—800 mm, 900 mm and 1000 mm—each with the same 1500 mm length and 900 mm height. Plastic cutting boards are available in 20 mm or 30 mm thickness, but are not included with the table.

The product sits in the catalogue under professional worktables and food-preparation surfaces.