Novameta table to dishwasher with short rolls and shelf 2300 mm

A stainless steel worktop on four legs forms a straight run from the dishwasher to the sorting area. Short roller sections let racks glide without lifting, while an undershelf keeps detergent and rinse aids within reach but off the work surface. The principle is simple: gravity moves the racks. The rollers are set at a slight decline so that loaded racks travel forward when nudged. No motor, no belt and no power is needed; the operator pushes the rack once and it coasts the rest of the way. This keeps the table narrow, quiet and easy to clean. To use the table, the operator slides a loaded rack from the dishwasher onto the first roller. A gentle push sends it down the line to the next station. Underneath, the shelf holds detergent bottles, rinse aids and cleaning cloths so they are always to hand but never in the way of the racks. The frame and top are made of stainless steel for hygiene and durability. The rollers are plastic-coated to protect crockery and reduce noise. The undershelf is also stainless steel, with a lip to stop items sliding off. The 2300 mm length gives enough space for two standard dishwasher racks to travel side by side or for one long rack to move without obstruction. The 600 mm depth keeps the table within the standard worktop footprint, while the 900 mm height matches most commercial dishwashers and sinks for a continuous work flow. The seamless stainless steel top sheds water and food debris directly into the dishwasher below, so the work surface stays dry between loads. The rollers lift out for thorough cleaning or replacement. The undershelf can be removed if a deep clean is needed. The table is supplied as a single unit, ready to place against a wall or between other workstations.