Novameta Table to Dishwasher with Sink and Frame 700

A stainless steel worktop with an integrated sink and undershelf organises the final rinse and transfer of crockery straight into the dishwasher.

The unit provides a flat, hygienic surface at a standardised height for scraping and stacking. A deep sink bowl set into the worktop allows pre-rinse under a tap or spray arm, removing food debris before the wash cycle. Below the worktop, a full-width shelf holds clean racks or waiting loads, keeping the workflow linear and the floor clear.

The operator scrapes plates onto the worktop, rinses them in the sink, then slides the rack directly into the adjacent dishwasher. No intermediate trolley or counter is needed, so the sequence stays compact and efficient.

Construction is a welded stainless steel frame with a 700 mm square worktop that includes the sink bowl. The undershelf is also stainless steel, matching the worktop for durability and ease of cleaning. All surfaces are seamless and rounded at the edges to prevent trapping debris.

The unit measures 700 mm wide, 700 mm deep and 900 mm high, fitting between standard kitchen modules and aligning with most commercial dishwashers. The footprint allows it to stand against a wall or between two workstations without disrupting traffic flow.

Cleaning follows the same routine as any stainless steel worktop: daily wipe-down with detergent, periodic sanitising, and occasional descaling of the sink if hard water is used. The seamless construction and rounded corners prevent dirt from collecting, so maintenance stays straightforward.