Novameta Table to Dishwasher with Sink and Shelf 1000

A stainless steel workstation that organises dirty crockery, cutlery and glassware before they enter the dishwasher. The unit combines a flat worktop for scraping and sorting, an inset sink for pre-rinsing, and a lower shelf that holds a standard dishwasher rack ready for loading.

The table stands between the dining area and the dishwasher, creating a continuous workflow. Dirty items are placed on the worktop, scraped of food waste, then rinsed in the sink to remove grease and debris. The clean rack on the shelf below receives the items in the same order the dishwasher expects them, so the operator can slide the rack straight into the machine without re-handling.

Construction is a welded frame of tubular stainless steel that supports the worktop, sink and shelf. The worktop is a single sheet of brushed stainless steel with rolled edges for safety and durability. The sink is inset into the worktop and has a standard waste outlet for connection to the kitchen drainage. The lower shelf is a flat stainless steel panel positioned at the same height as the dishwasher rack guides, so the rack slides on and off without lifting.

Controls are limited to the sink tap, which the operator uses to adjust water flow and temperature for pre-rinsing. The tap is mounted on the rear edge of the worktop, clear of the sorting area.

The footprint of 1000 mm by 700 mm fits alongside most commercial dishwashers, creating a compact pre-wash station. The 900 mm height matches standard worktop levels, so staff can work without bending. The open frame allows easy access for cleaning underneath and around the unit.

Cleaning follows the parts named: the worktop and sink are wiped down after each service, the tap is descaled regularly, and the shelf is cleared of any debris. The stainless steel surfaces resist corrosion and can be sanitised with standard kitchen chemicals.

The table is supplied as a single unit; no variants are listed for this model.