Novameta Wall-Mounted Table with Frame 3300 mm

A wall-mounted worktop frees the floor and keeps the kitchen organised. The table attaches to the wall with a welded stainless steel frame, leaving the space below clear for trolleys, bins or foot traffic. The frame's square tubes carry the weight of ingredients, utensils and appliances without sagging, while the pressed sandwich top spreads the load evenly across its surface. The table top is a single pressed panel that resists warping and damp. Its low-noise construction absorbs the clatter of pans and knives, making the kitchen quieter. An optional upstand along the back edge stops items sliding off and keeps the wall clean. To use the table, secure the frame to the wall at the required height, ensuring the fixings reach solid masonry or a steel stud. Once mounted, the tabletop bolts to the frame. Load the surface evenly up to the 120 kg limit, distributing weight across the full width rather than concentrating it in one spot. The 3300 mm length provides a continuous run for prep work, plating or holding equipment, while the 600 mm depth gives enough room for bowls, trays and small appliances without overhanging. The frame is welded stainless steel tube, chosen for its strength and resistance to corrosion in a busy kitchen. The table top is a pressed sandwich panel, a construction that combines rigidity with a smooth, easy-to-clean surface. An upstand, where fitted, is the same material as the top and runs the full length of the table. Controls are limited to the mounting hardware: wall brackets and bolts secure the frame, and the tabletop attaches with screws. No electrical or mechanical adjustments are needed. The 600 mm depth fits standard worktop depths and allows side-by-side placement of trays or cutting boards. The 750 mm height is a common worktop level, aligning with hobs, sinks and other equipment for a continuous workflow. The 120 kg load rating means the table can hold bulk ingredients, stacked trays or small appliances without risk of collapse. Cleaning is straightforward: wipe the pressed sandwich top with a damp cloth and mild detergent, avoiding abrasive pads that could scratch the surface. The stainless steel frame can be cleaned with a stainless steel cleaner to remove fingerprints and water spots. The optional upstand is wiped down in the same way as the tabletop. The pressed sandwich top lifts away from the welded frame so the entire work surface can be scrubbed under running water without tools. Two widths are available: 650 mm and 700 mm, allowing the table to match the kitchen's layout or the space available between walls or other equipment. The upstand is an optional extra, chosen at the time of ordering.