Novameta Wall-Mounted Table with Grid Shelf 1300

A wall-mounted work surface frees the floor and keeps the worktop at a fixed height without legs in the way. The table is fixed to the wall with brackets, transferring the load directly to the building structure. This arrangement leaves the space beneath clear for trolleys, bins or foot traffic, and the height remains constant regardless of the floor level or the equipment placed underneath. The tabletop is a pressed sandwich panel that resists bending and absorbs vibration, so chopping, rolling or assembling stays steady. A welded stainless steel frame supports the top and carries the grid shelf below, which holds trays, pans or utensils within arm's reach while allowing air to circulate. To install, the wall brackets are fixed to masonry or a steel stud at the marked positions. The table frame is then lifted onto the brackets and secured. The grid shelf is slotted into place on the frame rails. Once mounted, the tabletop is ready for use; no levelling is needed because the wall sets the height. The construction uses a 25 × 50 mm stainless steel tube frame, pressed sandwich tabletop and a grid shelf of stainless steel rods. An optional upstand can be fitted along the back edge to prevent items sliding off. The table is 1300 mm long, 600 mm deep and 750 mm high, giving a work surface that accommodates two gastronorm pans side by side. The 120 kg load rating applies to an evenly distributed weight, so the tabletop can carry multiple pans, a mixer or a stack of plates without sagging. The seamless pressed top and rounded tube frame let grease and water run off instead of pooling, so a single wipe with a damp cloth restores the surface after a busy service. The grid shelf lifts off for separate cleaning, and the open frame allows access to the wall behind for periodic inspection and cleaning.