Novameta Wall-Mounted Worktop with Reinforced Shelf 2400 mm

A wall-mounted stainless steel worktop creates a fixed preparation surface that frees floor space in a busy kitchen. The table is secured to the wall at the correct working height, leaving the area beneath clear for trolleys, bins or mobile equipment. Because the load is carried by the wall rather than legs, the surface can support heavier items without sagging or shifting during use. The tabletop is formed as a pressed sandwich panel, combining a rigid core with smooth stainless steel faces. This construction resists bending under weight and dampens vibration, so chopping, rolling or mixing produces less noise than on a solid sheet. The welded frame of stainless steel tube distributes the load evenly across the wall fixings, preventing localised stress that could loosen brackets over time. To use the table, position it at the desired height against a sturdy wall, mark the fixing points, and secure the frame with suitable anchors. Once mounted, the worktop is ready for immediate use. The optional upstand can be fitted along the back edge to contain spills and prevent items from sliding off during preparation. The tabletop measures 2400 mm in length and 600 mm in depth, providing a continuous work surface for large trays, bulk ingredients or multiple stations. The frame height of 750 mm places the surface at a comfortable standing height for most users. A uniform load capacity of 120 kg allows the table to support heavy mixers, stacks of sheet pans or large containers without flexing. The welded stainless steel frame and pressed sandwich top require minimal upkeep. After use, wipe the surface with a damp cloth and mild detergent to remove food residue. Avoid abrasive pads that could scratch the finish. The frame can be cleaned with the same solution, paying attention to joints where debris may collect. The pressed sandwich top lets you wipe spills straight off without lifting a single panel. Two widths are available: 650 mm with a tolerance of plus 3 percent, and 700 mm with a tolerance of plus 5 percent. An optional upstand can be added to either width.