Novameta Work Table with Integrated Cutting Board Space

A stainless steel work table built to hold a plastic cutting board directly on its surface, keeping food preparation organised on a single stable platform. The table provides a dedicated space for a board 300 mm or 400 mm wide, so the board sits flush without sliding while the operator chops, slices or portions. The board itself is not supplied, allowing the kitchen to choose the thickness and material that best suits the task. The table stands on a welded stainless steel frame of square-section tubes. Four adjustable feet raise or lower each corner by up to 65 mm, letting the operator level the table on uneven floors or set a slight slope for drainage. The feet are made of stainless steel and thread through the legs, so they stay clean and resist corrosion even in wet areas. The worktop is a single reinforced sheet welded to the frame. This construction prevents flexing under heavy loads and stops liquids from seeping underneath. The top is sized to fit standard plastic cutting boards, leaving enough overhang for easy lifting. Two board thicknesses are accommodated: 20 mm and 30 mm, so the kitchen can switch between a lighter board for everyday use and a thicker one for heavy chopping. Legs and cross-braces are made of 40×40 mm and 40×20 mm stainless steel tube, giving the table strength without excess weight. The frame is welded throughout, so there are no loose joints or fasteners that could work loose during cleaning. The entire unit is designed for wash-down with hot water and detergent, and the smooth welded seams leave no crevices where dirt can collect. Overall dimensions of 1000 mm long, 700 mm wide and 900 mm high give the table a compact footprint that fits between other workstations or against a wall. The height places the work surface at a comfortable level for standing tasks, while the width allows two operators to work side by side when needed. Cleaning is straightforward: the operator removes the cutting board, wipes the top and frame with a damp cloth and detergent, then dries the surface to prevent water spots. The stainless steel feet let you fine-tune the table height so the cutting surface stays exactly flush with your existing counters and sinks.