Novameta Z-S Sliding Partitions for Commercial Kitchens

Sliding partitions let a professional kitchen organise space without fixed walls or permanent construction. A track mounted at ceiling or worktop level carries the panels on rollers, so the operator can open or close the division by hand. The method removes the need for cupboard doors that swing into the aisle or for permanent walls that block reconfiguration when the menu or the shift changes. Partitions slide along the track and stack neatly at one end, leaving the full width of the kitchen available when the division is not needed.

The sequence of use is simple. The operator pulls the first panel across the opening, then the next, until the desired width is closed. Each panel locks into place with a catch or a magnetic seal, so the division stays secure while work continues on either side. When the partition is no longer needed, the panels slide back along the track and stack in the allocated space, clearing the floor for traffic or for a different layout.

Novameta Z-S partitions are constructed from lightweight aluminium frames that keep the weight low enough for easy manual operation. The panels themselves are filled with sound-absorbing material, so the partition reduces noise transfer between work zones. The track is fixed to the ceiling or to an existing worktop with brackets, and the rollers run smoothly without lubrication, so upkeep is limited to occasional cleaning of the track and the panels.

Each partition is supplied as a single unit ready to install. The catalogue places these partitions in the section for flexible kitchen infrastructure, where they sit alongside mobile workstations and retractable screens rather than with fixed walls or built-in cupboards.