Stalgast Icorner Table External 90° Worktop Unit

An external 90° icorner table creates a continuous work surface around a right-angled corner without interrupting the workflow. The unit fits against two walls or existing runs of equipment, turning an awkward space into a usable stretch of worktop. The angled front panel bridges the gap between the two sides, allowing staff to slide trays, pans and utensils across the corner without lifting or changing direction.

The table provides a flat, rigid surface for food preparation, plating, holding hot or cold stations, or staging mise en place. Because it is external, the corner piece projects into the room rather than sitting inside the angle, so it does not reduce the usable floor area behind it. This layout keeps the kitchen floor clear for movement and lets the corner remain accessible for cleaning or storage beneath the overhang.

To use the icorner table, position it against the walls so the two straight edges align with the existing runs of worktop or equipment. Secure it in place to prevent movement, then load the surface with the required tools, containers or appliances. The stainless steel top resists heat, stains and impact, and can be wiped down between tasks without absorbing moisture or harbouring bacteria.

Construction is entirely in stainless steel, forming a seamless, non-porous surface that meets hygiene standards for professional kitchens. The 1090 mm length, 655 mm width and 880 mm height create a footprint that fits standard kitchen modules and leaves enough clearance for operators to work comfortably on either side.

No controls are fitted; the unit is a static work surface.

The dimensions determine where the table can be installed: 1090 mm along each wall, 655 mm deep from the corner into the room, and 880 mm high from floor to worktop. The weight, though not stated, is typical for stainless steel catering tables, so it can be moved by two people or a trolley but is not designed for frequent relocation.

Cleaning follows from the materials: wipe the stainless steel surface with a damp cloth and mild detergent after each service, then dry to prevent water marks. The seamless construction leaves no crevices for dirt to collect, so routine cleaning is quick and thorough.

The product is listed in the Stalgast catalogue under Work Tables and Preparation Surfaces, in the section for Corner Units.