Tefcold Condenser Clip for Refrigeration Units

A condenser clip holds the condenser coil firmly in place within a refrigeration unit. The coil carries hot refrigerant gas, which must shed its heat to the surrounding air. If the coil shifts or vibrates, the contact with the airflow weakens, the heat exchange slows, and the unit struggles to maintain the set temperature. The clip presses the coil against its mounting points, keeping the fins aligned and the air passage unobstructed.

Fitting the clip follows the coil installation. The operator slides the clip over the coil tube or fin stack, then presses it into the pre-drilled hole or slot on the condenser frame. Some clips snap shut; others require a quarter-turn or a small screw to lock. Once secured, the clip prevents the coil from sagging or rattling, even when the compressor cycles or the unit is moved.

Condenser clips are typically made of corrosion-resistant metal or durable plastic, chosen to withstand the temperature swings and moisture inside the condenser housing. The material must not deform under heat or become brittle in cold, ensuring the clip remains tight over years of operation.

This spare part fits Tefcold refrigeration units where the manufacturer specifies condenser clip article 13321. Check the unit's parts list or service manual to confirm compatibility before ordering.

In the catalogue, the condenser clip is listed under refrigeration spares, coil mounting hardware.