HENDI Extendable Sink Colander 360x240 mm

A sink colander that expands to fit most commercial sinks, holding vegetables, pasta or rinsed ingredients clear of the water. The fine mesh allows water to drain while keeping small items contained, so nothing is lost down the plughole or left floating in the sink.

The colander rests on its own support legs inside the sink, keeping the base above the bottom and letting water circulate freely underneath. When the sink is needed for other tasks, the colander lifts out in one piece, leaving the worktop clear.

Operation is straightforward: place the colander in the sink, extend the handles until they grip the sides, then load with produce. The rubber-coated ends prevent slipping, even when the sink is wet. After use, collapse the handles to the minimum width for storage or dishwasher loading.

Constructed from fine stainless-steel mesh with rubber-coated steel handles and support legs. The mesh is dishwasher safe, and the rubber coating resists heat and detergents, so the colander can be cleaned alongside other kitchenware without special handling.

The 360 mm width at rest extends to a maximum of 545 mm, allowing it to fit sinks of different sizes without overhang. At 0.63 kg, the colander is light enough to lift with one hand when full, yet stable enough to stay in place during rinsing.

Cleaning follows from the materials: the mesh and rubber-coated parts can be run through a dishwasher programme, or washed by hand in the sink. No disassembly is required, and the fine mesh does not trap food particles once rinsed under a tap.

The catalogue places this colander in the sink accessories section, alongside other tools that organise rinsing and draining in a professional kitchen.