Beer Set ZP for Professional Bars

A stainless steel worktop and under-bench unit combined in one assembly, the BHS Beer Set ZP gives a bar its service surface and storage cupboard in a single footprint. The set is built for beer dispensing: the top holds taps, drip trays and glass racks, while the lower section organises kegs, gas bottles and cleaning supplies beneath the same counter. Because both parts share a frame, the unit stays aligned and stable without extra fixings to the floor or wall.

The worktop is a flat, seamless surface that resists spills and heat. It supports the weight of filled kegs and the daily traffic of bar staff without flexing. Below it, the bench section is a cupboard with a single door or shelf, depending on the variant. The interior is open, so kegs and gas cylinders can be rolled in and out without lifting. The depth of the bench matches the depth of a standard keg, so the unit sits flush against a wall and does not waste floor space.

To use the set, the operator loads kegs into the bench section, connects the gas and beer lines, and places drip trays and glass racks on the worktop. The taps are mounted on the rear edge of the top, so the beer lines run straight down into the bench. The worktop height is standardised for bar service, so staff can work without bending or reaching. When the service is finished, the taps and drip trays are removed for cleaning, and the worktop is wiped down with a sanitising solution. The bench section is emptied and cleaned with a damp cloth, and the door or shelf is left open to air dry.

The set is constructed from stainless steel throughout. The worktop is a single sheet with folded edges for rigidity, and the bench frame is welded for strength. The door, if present, is also stainless steel and hangs on adjustable hinges. No internal fittings or shelves are specified, so the interior remains open for kegs and bottles.

The dimensions of the set are given as two assemblies: the worktop measures 180 cm wide, 60 cm deep and 79 cm high, while the bench section is 180 cm wide, 36 cm deep and 47.5 cm high. The worktop width matches the bench width, so the two parts align when placed together. The depth of the bench is less than the worktop, so the worktop overhangs and creates a lip for spills. The height of the worktop is standard bar height, so it matches other counters and equipment in a professional kitchen.

Cleaning is limited to the parts named: the worktop, the bench interior and the door. The stainless steel surface can be cleaned with a damp cloth and a mild detergent, and the bench interior is wiped down after each service. The door, if present, is cleaned on both sides, and the hinges are checked for alignment. No other maintenance is required.

The set is supplied as a single article, with no variants or options named in the reference entry.